Abstract

ROQUE-TORRES, Gina; KIM, Jessica; DANTAS COSTA, Eliana  and  OYOYO, Udochukwu. Evaluation of customized peripheral sealing device acceptance for surgical/medical masks among dental professionals during early COVID-19 pandemic. Odovtos [online]. 2022, vol.24, n.3, pp.139-151. ISSN 2215-3411.  http://dx.doi.org/10.15517/ijds.2022.50444.

A 3-dimensional (3D) printed custom-frame can improve the peripheral seal of readily available surgical/medical masks. This study aimed to assess the acceptance of a 3D-printed custom-frame with the American Society for Testing and Materials (ASTM) surgical/medical masks and the use of a face shield. A total of 206 subjects from a dental school participated, who answered a multiple-choice questionnaire. Participants received an invitation through the institutional email of the school via Qualtrics platform. 3D printed custom-frames were fabricated for each participant. According to their response, participants were divided into 4 groups: mask only (M), mask and frame (MF), mask and face shield (MFS), and all 3 personal protective equipment (MFFS). Data was analyzed in absolute and relative frequency. The acceptance of a 3D-printed custom-frame in the group MFFS varied between ''poor''/''very poor'' (44.7%). It allowed ''good'' performance of routine procedures (40.3%), but ''poor'' visual quality (48.1%). Musculoskeletal tolerance and ease to perform movements were adequate. There was no interference in olfactory sensitivity (44.7%) or in the ability to breathe (34.5%). Finally, it showed "moderate pain" (48.1%) on the ear and "no pain" (38.9%) on the head. The 3D-printed custom-frame adapted to ASTM surgical/medical face masks showed reasonable tolerance. Side effects of ear pain ranging in degrees were noted. Further research is indicated to evaluate safety, comfort, compliance, side effects, and occupational hazards of long-term use of enhanced PPE recommendations.Avoiding the recurrent outbreaks of COVID-19, the use of PPE by the public is necessary. Improper PPE use is a major source of concern for human and environmental health. Preventing such activities can be done by following steps involved in PPE disposals or by getting a new way to re-use such as improving peripherical sealing. Our work highlights that a custom-frame can improve protection, without adverse effects.

Keywords : ASTM; Seal peripheral; Fit factor; Dentistry.

        · abstract in Spanish     · text in English     · English ( pdf )