Resumen

BENAVIDES-GARCIA, Marianella; HERNANDEZ-MEZA, Erick  y  REYES-CARMONA, Jessie. Ex Vivo Analysis of MTA FLOW® Biomineralization and Push-Out Strength: A Pilot Study. Odovtos [online]. 2021, vol.23, n.1, pp.76-90. ISSN 2215-3411.  http://dx.doi.org/10.15517/ijds.2020.41780.

This study evaluated the biomineralization processes and push-out strength of MTA Flow® with radicular dentine in three different consistencies. The push-out test was performed on an ex vivo model, using 2mm thick dentin discs from the middle third of the root with standardized cavities of 1.5 mm. Samples were filled with MTA-Angelus (Angelus Dental, Brazil), Biodentine (Septodont, France), MTA Flow® Putty (Ultradent, USA), MTA Flow® Thick or MTA Flow® Thin. The samples were divided into 3 groups: subgroup 1 (n=5), analysis of the biomineralization process; 2 (n=20), evaluation of the bonding strength and push-out resistance; and 3 (n=5), evaluation of the cement/ dentin interface. The samples filled with Biodentine had a higher precipitation of carbonate apatite. However, there was no significant difference between MTA-Angelus, MTA Flow® Putty, or Thick (p=0.0536), but there was a significant difference in the Thin group (P<0.05). The samples with Biodentine displayed the greatest release of calcium ions. The formation of a partially carbonated intermediate apatite layer was observed in all groups. Zones of biomineralization were observed at the interface but were not continuous. After 72 hours, a significant difference was found between the Biodentine and MTA Flow® Thin groups (p=0.0090) in the push-out test. The samples submerged in phosphate-buffered saline (PBS) for 15 days showed a significant difference between all groups and MTA Flow® Thin (p=0.0147). Putty or Thick consistencies presented a similar bonding strength to MTA-Angelus and Biodentine. MTA Flow® Putty and Thick consistencies show a good adaptation to dentin, similar to MTA-Angelus. However, the thickness of the interface was lower compared to that of Biodentine. MTA Flow® Thin, despite their tubular infiltration, results in gaps and a defective peripheral seal.Therefore, MTA Flow®, in Putty or Thick consistencies, presents a biomineralization process and push-out strength similar to MTA Angelus and Biodentine, however, both characteristics decreases considerably in Thin consistency.

Palabras clave : Bioactivity; Biodentine; Biomineralization; Carbonate apatite; MTA Flow; Push-out test.

        · resumen en Español     · texto en Inglés     · Inglés ( pdf )